Version 10 (modified by shinton@…, 6 years ago) (diff)

--

The RT-N16 is now supported for testing purposes

Firmware debwrt-firmware-brcm4716-squashfs-bgmac-enabled.trx
Modules Generic brcm47xx tar.gz
RootFS mipsel
  • robocfg is used to configure the manageable switch ( /etc/init.d/robocfg ) - not yet working

See thread here for support discussion.

Compiling From Source

Follow instructions here with a few modifications:

1. After checking out the DebWrt Build Environment, replace the Config, Openwrt & Config.in files with the ones in this archive: brcm4716-debwrt-sourcefiles.tar.gz
2. After running "make openwrt/menuconfig, run make openwrt/kernel_menuconfig and ensure that Device Drivers -> Sonics Silicon Backplane -> SSB Broadcom DMA library/64-bit SSB DMA cores support is set, then enable Device Drivers -> Network device support -> Ethernet (1000 Mbit) -> Broadcom SSB GMAC ethernet driver
3. Follow the rest of instructions as shown on the above link, remember to run second stage install after flashing device.